Hello Lee, Is your battery an Aolithium? Because you said the car wouldn't start, and our LiFePO4 batteries are not car starting batteries, and our batteries are the deep cycle battery used to po...
Hello Michael, The app cannot modify the charging current. Can you modify the controller parameter? if so, you can turn down the output current of the controller.
Dear Michael,The 12V 100Ah battery float voltage is 14V, storage temperature -20°C~ 35°C / -4°F~95°F. If you need to store your batteries for a long time in the off-season, there a...
Hi Jeff, 1) If the bolts are short, you could use longer M8 bolts of the same diameter and replace the current one.M8-1.25 x 12mmThis link is intended as a reference only: https://amzn.to/3Gv...
You can download the xiaoxiang app from this link： https://cdn.shopify.com/s/files/1/0583/7271/8767/files/xiaoxiang-3.1.1021.apk.1_1.1?v=1647574525
@Alan McR The email we sent you was returned, can you provide us with another email address?
Hello Alan, 1) Our lithium batteries are deep cycle batteries and cannot be used as starting batteries for vehicles. 2) The "Battery Over-discharge voltage" level can be changed, but after the da...
@John K Johnson https://balmar.net/mc-618-voltage-regulator/ The Max Charge MC-618 should be available, the principle is to adjust the output voltage by comparing the battery voltage to ach...
We recommend that you use an inverter ≤ 2500W. 3000w inverter can also be used, but when you take more than 100A load, you need to pay attention to the use of temperature range: -10 ° - 50 ...
The lithium battery cannot be charged with vehicle alternator.You can use lithium battery chargers, standard charger, solar or wind charge controller to charge our LiFePO4 deep cycle battery.
If you use utility power (AC), shore power (AC) or generator (AC) to charge the battery, you can use an AC to DC charger.If you use your vehicle’s alternator and starting battery to charge th...
As the battery is completely discharged to an undervoltage protected state, so the general charger can not charge the battery.The battery can be restarted in several ways:1) Charging the battery wi...
The recommended charger for lithium batteries is less than ≤ 0.5C. For example ≤ 50A for 100Ah batteries, ≤ 10A for 20Ah batteries.
Our 12V 100Ah lithium batteries have low temperature protection, but no self heating capability.Here is the specification: https://cdn.shopify.com/s/files/1/0583/7271/8767/files/Aolithium_12V100Ah_...
Our Aolithum 12V100Ah batteries can connect in parallel for 200Ah, 300Ah, 400Ah (maximum) larger capacity, or connect in series for 24 volts (maximum) battery bank.However, it can not be connected ...
Connected in parallel:1) Recommend to fully charge the batteries before parallel connection.2) The voltage of the two batteries should be the same (error range 0.1V).3) The cable length between bat...
There are two ways to solve the problem:1) Use shims in the recessed terminals, shim thickness not less than 8 mm.The recommended shims size: M8*20*8Inner diameter: M8Outer diameter: 20mm (allowabl...
Our 12V100Ah batteries can only be connected in series or parallel. We do not recommend string batteries in series and parallel at the same time, as it may cause circuit problems.
1) Is your Bluetooth connection to other apps or is there any other battery app installed in your phone? because the data saved on the phone in the two apps are in conflict, the original data cache...
The data of the two batteries are independent.Each battery has a Bluetooth number, when you use it, you connect which battery's Bluetooth, the APP will show this battery's data.(Each battery has a ...
